Generally, the shelves above your eyeline have brackets on top and the shelves below your eyeline have brackets on the underside of the shelf, to ensure they are less visible. ![]() Whether the bracket attached to the top of the shelf or the bottom surface, depended on how you viewed the tree. Then the shelf was put back in place and screwed to the bracket, as well as the adjoining branch. After putting wall plugs in the holes, the bracket was screwed on to the wall. Then the shelf was removed and the holes for the bracket were drilled in the wall. To hide the L brackets, their position was marked onto the wall whilst holding the shelf in place. When making the branches, you want to keep them supported, so ensure that there is an L bracket at the end of each branch and if they are long or very wiggly, at least one in the middle. This will allow the screw to pull that board up nice and close to the other board. Once the desired angle was achieved, I drilled the screw holes for the board I was attaching to the tree. Some sanding was required to match the sizes of the mating face, due to the different angles they were cut at. Then I marked a pencil line that was parallel with the end of the plank I was joining to and cut that line on the table saw. However, I didn't have anything to measure the angle, so I cut the piece of wood to length, then held it up against the wall, adjusting the angle until it looked like the plan. When you have to join angles, if you have measured them and know what that angle is, then you need to divide that angle by two so that both pieces of wood join together at the same point with the same size mating face. There will be a lot of pieces of wood to cut for this and every angle you cut will probably be different but it will look good in the end. ![]() Use photos of real trees for inspiration. If you include these, it will look more like a circuit board. Quick Tip: If you want a more natural looking tree, avoid perfectly level shelves. If you are doing a full wall tree, try not to have the tree touch the walls or the ceiling, otherwise it will look like it is too big for the room. This made it easier for measuring and consistency during the building phase and made the design more balanced. To make designing easier, I mainly chose lengths to the nearest 0.5cm in the sketch. Compared to traditional DI65 planks that use visual grading, our mill’s proof testing process has produced a lower variability in flatwise bending strength for 2200F. Also be aware of any wires in the wall which you will need to avoid when drilling into the wall. The 2200F MSR 1.8E Solid Sawn Scaffold Plank is a large leap forward in performance and quality compared to the outdated DI65 planks, revolutionizing scaffolding boards for good. ![]() You need to measure the space the tree is going into and work around fixed items on the wall like sockets, switches and thermostats that you cannot move. This means you can go through a lot of iterations without having to waste wood. I sketched my plan at a ratio of 1:20 so every 20cm of wall was 1cm in my sketchbook. Then I sketched out the tree design and estimated the length of each section, although this may change a small amount when you are making the tree. I started by drawing a box which is the size of the wall/space for the bookshelf.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |